Floorboards

One last test fit before coating with Raptor bed liner. I had not had these in since I made them many months ago. Certainly not since I covered the interior. I needed to make sure there was clearance from sides so there is no rubbing. I did have to trim the two front boards on the outside about a 16th of an inch. I also opened up the screw holes to the next size bit to allow for some movement in positioning. The fuel line openings are good as is the drain openings.

I didn't put the tunnel pieces in as nothing changed with them. Even though I trimmed the outside edges the positions of the boards did not change.

Everything checks out. Next up, Raptor...