I've been trying to figure out the layout of all the parts that need to be mounted to the firewall. First task was to decide where to mount all the parts that need to go on the upper part of the firewall. This is because I needed to drill through the fiberglass windshield mount before riveting it to the firewall. I wanted to debur the holes and the fiberglass before riveting together. Once mapped out, I had to remove the engine to allow drilling. After the holes were drilled and deburred, I riveted the fiberglass to the firewall and then mounted the voltage regulator, the ground tree, and the coolant tank.
While I was drilling holes I figured out where the two solenoids were to be mounted and got them temporarily mounted.
I have the main engine/ECU harness and fuel delivery holes to go. I'll get those taken care of the end of next week when I return from a trip.
