I decided on some graphics for the fuselage. I ordered them from Aerographics. They were really easy to work with and had a quick turn around. I have several ideas and just started with the SuperSTOL logo down the side of the fuselage.
Today, I first leveled the fuselage head rack, then taped the logo in place to see where I wanted it. After futzing with it for a while, I was finally happy with the position. I measure up from the floor to the bottom of the first letter, then matched that in the rear to give me a level layout. I marked the fuselage with pencil registration marks so I place it back into position when ready.
I cleaned the side of the fuselage with a soap and water mixture and wiped it clean. I then wet the surface with the same Dawn/water solution, peeled the backing off the piece, sprayed it and then placed the piece into position. The soapy water solution allows one to fine tune the position the piece. Once in position I used a small plastic squeegee to wick the solution/bubbles from behind the piece. I worked from the center out front and back until most all of the solution was out. Then I slowly and carefully peeled the top layer off leaving the lettering behind. Once the top layer was off, I looked for and squeegeed any remaining bubbles from behind the lettering, gave it a final wipe off and left it to dry overnight.
It went on without a hitch and looks pretty good. Tomorrow, the other side...
Now for the other side of the fuselage. Following the exact same procedure, I set up to mount the logo on the passenger side. No issues and it went on just as smooth.
