Started working on the Aileron connections today. Before I could make up the connections from the control stick to the turnbuckle, I had to make a cable pass through in the side panels next to the seat. Took a little while to figure out how I wanted that to look. Anyway, after a several hours of trial and error, I came up with the following "slot". This works well and looks pretty good too.
However, I am thinking I would like to design some type of cover to go over this cable and slot to prevent anything from falling into and jamming the free travel of the cable. I will think about this over the next few days.
Now to do the same on the other side.
